Chamfering/ deburring if there is no chamfer.
This instruction only refers to an 45 degree chamfer and a 45 degree chamfer cutter.
With closed contours
Select a contour => 2,5 Axis milling => profiling
Tab card milling parameter
- Allowance on contour: “Please enter here the chamfer width with (-sign).”
- whole step “Here you enter the chamfer width plus a smaller addition.”
- Infeed per step: Here you can enter 0.”
- Cutter radius compensation: “Climb and up-cut milling”.
- closed contours: Select “outside or inside” .
Tab extended
-"sharp corners”
Tab - entry-/exit
- "entry linear or circular"
- "exit linear or circular"
Tab card tool
- milling tool type: "Conical milling tool"
- Diameter: "Should be well-suited for the chamfer"
- Projection length: "Such as the milling tool"
- Cutting length: "such as the milling tool"
- Angle: "45 Degree"
*************************************
With open contours
Select contour => Control the running direction of the contour (polylinie) => 2,5 Axis milling => Profiling
Tab milling parameter
- Allowance on contour: “Please enter here the chamfer width with (-sign).”
- Whole step: “Please enter here the chamfer width plus a smaller addition.”
- Infeed per step: “Here you can enter 0”.
- Cutter radius compensation: Select “Left or right of the contour”.
- closed contours: “No selection”.
Tab extended
- "sharp corners"
Tab - entry-/exit
- "entry linear or circular"
- "exit linear or circular"
Tab Tool
- Milling tool type: "Conical milling tool"
- Diameter: "Should be well-suited for the chamfer"
- : "Such as the milling tool"
- Cutter length:"such as the milling tool"
- Angle: “45 Degree”
